3. To reset ALCI with a reset button, unit
should be unplugged. Then push in reset
button, and reinsert plug into outlet.
4. If ALCI is not functioning properly, return
appliance to nearest service center.
5. It is important that if immersion occurs,
this unit be brought to a service center. Do
not try to reset.
6. Be sure to repeat test every time you use
the unit, to confirm ALCI is operational.
Should the appliance go off and the reset
button pop up during use, this could indicate
a malfunction in the unit. Remove plug from
outlet and allow the hot air brush to cool.
Reinsert plug into outlet.
When using electrical appliances, especially
when children are present, basic safety pre-
cautions should always be followed, including
READ ALL INSTRUCTIONS
KEEP AWAY FROM WATER
DANGER— Any appliance is
electrically live even when the switch is off.
To reduce the risk of death or injury by
1. Always unplug appliance immediately
2. Do not use while bathing or in a shower.
3. Do not place or store appliance where it
can fall or be pulled into a tub or sink.
4. Do not place in, or drop into, water or other
5. If an appliance falls into water, unplug
immediately. Do not reach into the water.
WARNING — To reduce the risk of
electrocution, fire, or injury to persons:
1. This appliance should never be left
unattended when plugged in. Do not pull,
twist, or wrap line cord around appliance.
2. This appliance should not be used by, on
or near children or individuals with certain
3. Use this appliance only for its intended
use as described in this manual. Do not
use attachments not recommended by the
4. Never operate this appliance if it has
a damaged cord or plug, if it is not working
properly, if it has been dropped or dam-
aged or dropped into water.
appliance to an authorized ser
for examination and repair.
5. Keep the cord away from heated surfaces.
Do not wrap the cord around appliance.
6. Never block the air openings of the appli-
ance or place it on a soft surface, such as a
bed or couch, where the air openings may be
blocked. Keep the air openings free of lint,
hair, and the like.
7. Never use while sleeping.
8. Never drop or insert any object into any
opening or hose.
9. Do not use outdoors or operate where aero-
sol (spray) products are being used or where
oxygen is being administered.
10. Do not use an extension cord with
11. Do not direct hot air toward eyes or other
heat sensitive areas.
12. Attachments may be hot during use. Allow
them to cool before handling.
13. Do not place appliance on any surface
while it is operating.
14. While using the appliance, keep your hair
away from the air inlets.
15. Do not operate with a voltage converter.
This appliance is intended for household use.
Use on Alternating Current (60 hertz) only.
Standard curling appliances are designed to
operate at 110 to 125 volts AC.
This appliance has a polarized plug (one blade
is wider than the other). As a safety feature,
this plug will fit into a polarized outlet only one
way. If the plug does not fit fully into the outlet,
reverse the plug. If it still does not fit, contact a
qualified electrician. Do not attempt to defeat
this safety feature.
CHECK ALCI SAFETY FEATURE EVERY TIME
YOU USE APPLIANCE.
This appliance is equipped with an Appliance
Leakage Circuit Interrupter (ALCI), a safety
feature that renders it inoperable under some
abnormal conditions, such as immersion in
To make sure the ALCI is functioning properly,
perform the following test. The purpose of this
test is to allow you to make sure the water
sensing system (ALCI) is working.
1. Plug in the appliance and press test button
on plug (See appropriate diagram below).
2. The appliance will stop working. There will be
an audible click and reset button will pop out.
HOW TO STYLE WITH YOUR
HOT AIR BRUSH
Partially dry hair by either blow-drying or let-
ting the hair dry naturally. When hair is almost
dry, use the ceramic-coated 1
⁄4" brush to
create lift, volume and large, soft curls.
Beginning at the crown area, take a section
of hair and place the 1
⁄4" brush near the
root area. Slide the hot air brush toward the
ends, then wind toward the root area. Hold
for approximately 10 seconds, then gently
unwind the hair without tension. Continue
throughout the hair until styled as desired.
NOTE: To achieve maximum body, fullness
and curl, apply styling gel to the root area and
styling mousse to the ends. Then take small
sections of the hair, and curl it with the 1
barrel of the hot air brush.
USE OF THE CONCENTRATOR NOZZLE
Attaches easily to styler, directing airflow onto
a small section of hair. Build volume by direct-
ing the airflow at roots, against the natural
USE OF THE 3/4" NATURAL BOAR AND NYLON
Place the brush under hair, close to the roots.
Slide it down to hair ends. This will give perfect
shape to your hair style, while bristles and hot
air create a polished finish and add shine.
GET TO KNOW YOUR 1200 WATT
TOURMALINE CERAMIC HOT AIR BRUSH
2 speed settings
with 3-position power
selector switch (high/
⁄4" Tourmaline Ceramic-coated
Natural Boar and Nylon Bristle
Professional swivel power cord
¾" Natural Boar and
Nylon Bristle brush
STYLING WITH THE NEW TOURMALINE
Your new hot air brush has 1200 watts of
styling power. The 1
⁄4" brush barrel of your
new hot air brush has a Tourmaline ceramic-
coated surface, the newest in hair care
The Tourmaline Ceramic-coated surface
generates natural ions to eliminate frizz and
helps smooth down flyaways and frizzies.
As you wind each strand around the barrel, heat
is evenly distributed so that the style you create
has a salon-perfect, silky smooth, shining finish.
Hair easily slips right off the barrel after
The new Tourmaline Ceramic
™ Technology is a
pleasure to work with. It makes styling your hair
easier and the results more professional.
HOW THE CERAMIC HOT AIR
THE TOURMALINE/CERAMIC COATING
generates natural ions that can:
• neutralize the generally positive charge on
flyaway, frizzy hair
• reduces static electricity
• contribute to shine
1200 watts of styling power