Draper Silhouette/Series M

Draper Silhouette/Series M mode d'emploi

(1)
  • Your Draper screen can be mounted on a wall or suspended from the ceil ing,
    or mounted on special 6" extension bracket. Extension brackets must be
    ordered separately from Draper. With each method of installation, the case
    must be mounted level and with the fl at back parallel to the wall.
    To reduce the risk of personal injury, use only the hardware which comes
    with the screen or is specifi ed in these instructions.
    The screen (or extension brackets) should be mounted into studs or block ing
    in the wall/ceiling, or in drywall (minimum thickness
    1
    /
    2
    ") with specifi ed anchors.
    For any other type of installation, follow all local build ing and safety codes.
    Steel studs, concrete or cinder block walls and all other types of non-wood
    frame construction require the use of special screws or anchors. The se-
    lec tion of ap pro pri ate mounting hardware should be made by a qualifi ed
    pro fes sion al installer.
    When locating viewing surface and checking clearance for screen’s op er a tion,
    remember surface is centered in case. Handle case carefully to avoid scratch-
    ing. Regardless of mounting method, screen should be positively and securely
    supported so that vibration or even abusive pulling on the viewing surface
    will not cause case to work loose or fall. Installer must insure that fasteners
    used are of adequate strength and suitable for the mounting surface.
    Wall Mounting
    Mount 2, 3, or 4 aluminum brackets provided (“Z” Clips) on the wall at
    desired height, using appropriate fasteners. Verify that they are in line and
    level to fully engage with the mounting lip on back of screen case. 1
    5
    /
    8
    " of
    free space is required above the “Z” Clips to allow case lip to be engaged
    over the lip of the “Z” Clips.
    Engage the lip on back of screen case with lip of “Z” Clip and gently pull
    down to fully engage case to brackets.
    Ceiling/Suspended Mounting
    Locate two offset ceiling brackets (supplied) and slide these into the chan-
    nel on top of screen case by aligning the chamfered edges of each bracket
    parallel to the channel length. Allow bracket to drop against bottom of
    channel and then rotate bracket counter-clockwise. Slide one bracket to
    each end of screen case until it stops against end cap of case. Tighten two
    set screws to lock bracket in place. Make sure that the fl ange of the ceiling
    bracket that has four holes is extended beyond the end caps of the case.
    Repeat above procedure for second ceiling bracket, making sure to slide it
    towards opposite end of case.
    To mount against ceiling, hold screen case against ceiling and mark
    mounting hole locations. Each brack et has 2 holes towards the front edge
    and 2 holes towards the back edge. Installer must use at least 2 fasteners
    per bracket with one fastener in one of the two holes clos est to back edge
    of bracket, and one fas ten er in one of the two holes closest to front edge of
    bracket. Installer must insure that fasteners are of adequate strength and
    suitable for the mounting surface chosen.
    To mount suspended from ceiling, the brackets need to be installed on
    screen case as noted above. Attach “S” Hooks (supplied) through the holes
    in the brackets. Select the set of holes that allows the screen to hang in a
    vertical position. The installer is to provide the materials and fasteners to
    attach the “S” Hooks to the ceiling. Installer must insure that the fasteners
    and suspension material are of adequate strength and suitable for the
    mounting surface chosen.
    Ceiling bracket in
    channel of case
    Ceiling bracket
    Mounting fasteners
    (supplied by others, 2 per bracket)
    (front of Silhouette case)
    (right end of Silhouette case)
    Installation/Operating Instructions
    Silhouette/Series M and C
    Manually Operated Projection Screens by Draper
    Lip on back
    of case
    "Z" Clip
    (wall mounting bracket
    supplied with Silhouette)
    Silhouette fully engaged
    on "Z" Clip
    Copyright © 2012 Draper Inc. Form SilhouetteM&C_Inst12 Printed in U.S.A.
    Caution
    Read instructions through completely before proceeding; keep
    them for future reference. Follow instructions carefully. Installation
    con trary to instructions invalidates warranty. Care in both mount-
    ing and correct operation willl assure long and sat is fac to ry service
    from your Draper screen.
    Screen should be accessible for complete removal should fabric
    become damaged or for service if required.
    Screen should be installed level (using a carpenter’s level).
    Nothing should be fastened to screen dowel or viewing surface.
    Operating crank for Series C is packed separately in screen car-
    ton. Do not discard with packing material.
    Note: Screen has been thoroughly inspected and tested at fac-
    tory and found to be operating properly prior to shipment.
    Installation
    ®
    If you encounter any diffi culties installing or servicing your
    screen, call your dealer or Draper, Inc., Spiceland, Indiana, (765)
    987-7999, or fax (765) 987-7142.
Draper Silhouette/Series M

Besoin d’aide?

Nombre de questions : 0

Vous avez une question sur le Silhouette/Series M de la marque Draper ou avez-vous besoin d’aide? Posez votre question ici. Fournissez une description claire et complète du problème et de votre question. Plus votre problème et votre question sont détaillés, plus il sera facile pour les autres propriétaires du Silhouette/Series M de la marque Draper de répondre correctement à votre question.

Consultez gratuitement le manuel de la marque Draper Silhouette/Series M ici. Ce manuel appartient à la catégorie écrans de projection et a été évalué par 1 personnes avec une moyenne de 8.8. Ce manuel est disponible dans les langues suivantes: Anglais. Vous avez une question sur le Silhouette/Series M de la marque Draper ou avez-vous besoin d’aide? Posez votre question ici

Spécifications du Silhouette/Series M de la marque Draper

Généralités
Marque Draper
Modèle Silhouette/Series M
Produit écran de projection
EAN 641092175254
Langue Anglais
Type de fichier PDF
représentation / réalisation
Format d'image 16:9
Largeur de visualisation (l) 1549
Hauteur de visualisation (h) 2311
Taille d'écran totale (hauteur x largeur) 124 x 220
Diagonale 100 2011-05-04 11:27:54 2012-06-08 13:40:02 8737 17 3 kg 2010-10-11 16:57:50 2012-06-08 13:40:02 8738 18 3 MHz 2010-10-11 16:57:50 2012-06-08 13:40:02 8739 21 3 x 2010-10-11 16:57:50 2012-06-08 13:40:02 8741 23 3 Mbit/s 2010-10-11 16:57:50 2012-06-08 13:40:0
Format HDTV
Angle de vision 60
Gain de l'écran 1.0
Cycle operating par jour (max) Manuel
Poids et dimensions
Carter L1 2413
Poids 18597
Design
Type de montage Mur
Couleur Tour/Case Blanc

ModesdEmploi.fr

Vous cherchez un manuel ? ModesdEmploi.fr vous permet de trouver le manuel que vous recherchez en un rien de temps. Notre base de données contient plus d'un million de manuels en PDF pour plus de 10 000 marques. Chaque jour, nous ajoutons les derniers manuels afin que vous trouviez toujours le produit que vous recherchez. C'est très simple : entrez le nom de la marque et le type de produit dans la barre de recherche pour consulter gratuitement et immédiatement le manuel de votre choix en ligne.

ModesdEmploi.fr

© Copyright 2020 ModesdEmploi.fr. Tous droits réservés.

Nous utilisons des cookies pour vous garantir la meilleure expérience sur notre site. Si vous continuez à utiliser ce dernier, nous considérerons que vous acceptez l'utilisation des cookies.

En savoir plus