Meliconi Goal Plus mode d'emploi

Meliconi Goal Plus
6.8 · 1
PDF mode d'emploi
 · 1 page
Anglais
mode d'emploiMeliconi Goal Plus
1. Make sure that the TV is ON.
2. Hold down the and
keys simultaneously until the light indicator at the top starts to ash
indicating that the remote control is in programming mode.
3. Press key four times then point the remote control at the appliance.
Press and release the key slowly several times.
STOP when your TV goes OFF.
4. When your TV is OFF, press the and keys simultaneously. When
you release the keys, three ashes indicate that the search operation
has been completed correctly.
Additional check
Check that all 7 keys are operating correctly.
If the commands work incorrectly or erratically,
you have probably entered a code for a similar
but different remote control.
In this case, repeat the search
procedure from point 2 until
all keys respond correctly to
the commands sent.
If you have any queries about Speedy Goal Plus:
• read this booklet carefully – this will help you to solve
almost all problems
• consult our Internet site www.meliconi.com to
answer all your queries more easily and quickly.
WARRANTY: 2 years
The warranty ceases to be valid if the product
is tampered with or used incorrectly.
Remote control model Speedy Goal Plus
Purchase date___________________
Identify and take note of the TV code which you have searched for,
following the code noting procedure
(see “PROGRAMMED CODE NOTING” section).
PROGRAMMED CODE NOTING
When you have programmed Speedy Goal Plus
Meliconi, note down the code on the label
in the battery compartment cover.
To nd the code for your remote control:
1. Hold down the and keys simultaneously
until the light indicator at the top starts to ash
indicating that the remote control is searching for
the code.
2. Release the keys and, within 12 seconds,
press and simultaneously.
3. Release and and pay attention to the
ashing of the LED: a long ash corresponds to a +
while a short ash corresponds to a - .
Note the sequence of the
9 ashes
and note them
down on the label in the battery compartment cover,
from left to right.
RE-PROGRAMMING YOUR REMOTE CONTROL BY
ENTERING THE CODE NOTED DOWN
If the remote control is no longer programmed because it has
been left without batteries for a long time or has at batteries, you
can re-program it quickly as follows:
1. Hold down the and keys simultaneously until the light
indicator at the top starts to ash indicating that the remote control is
programming.
2. Release the keys and, within 12 seconds, using the
and keys, enter the nine-sign code which you noted down
before. At the end,
three ashes
indicate that the code has been saved
correctly. If not, try the code entry procedure again from point 1.
USING YOUR REMOTE CONTROL
Once you have programmed Speedy Goal Plus, you can turn ON your
TV in three ways:
• Press or .
• Press .
• Press and simultaneously: this sends the code for programme 1.
To return to programme 1 directly, press and simultaneously.
TROUBLESHOOTING
PROBLEM
1.
The TV does not respond and the light indicator does not light up when you press a key.
2.
The TV does not respond but the light indicator does light up.
3.
The TV does not respond and the light indicator ashes.
4.
Not all remote control commands are working correcting.
5.
The and keys do not select the programmes.
SOLUTION
1. Check that the
batteries are tted
correctly. If neces-
sary, replace them
with 2 new 1.5 V
AAA/LR03 alkaline
batteries.
2. Check that the
batteries are new
and that the remote
control is pointing
at the appliance
without any ob-
stacles in the way.
If required, reset
the remote control
code by repeating
the programming
procedure.
3. Batteries are low.
Replace them.
4. You may have
used the wrong
code. Reset the
remote control
code, following
the programming
procedure.
5. The original
remote control may
not have had this
function. In this
case, set the code
(press 9 times)
as described in the
PROGRAMMING
YOUR REMOTE
CONTROL section
above.
INFO LINE
Agent’s stamp
NOTE: DURING THE SEARCH OPERATION, THE LIGHT INDICATOR FLASHES MORE QUICKLY. THE LIGHT INDICATORSTOPS FLASHING AND YOUR REMOTE CONTROL LEAVES PROGRAMMING MODE IN THE FOLLOWING CASES: • if no keys are pressed for 12 seconds • if you press keys other than those indicated • if the code search list is completed. In this case, visit www.meliconi.com
Thank you
for choosing Meliconi.
This simpli ed universal remote control contains all the main functions of most
TV remote controls on the market.
Insert the batteries and program your remote control before using it.
The remote controlrequires 2 new AAA/LR03 alkaline batteries.Insert the batteriesas shown:
FITTING THE BATTERIES
Batteries must be changed once a year.
Change the batteries if the light indicator starts to ash during use. The
batteries are low.
When removing batteries, insert the new ones within 5 minutes or you may
have to reprogram your remote control.
Make a note of the code for your TV on the adhesive label supplied inside
the battery compartment cover. This note will be handy if you have to
reprogram your remote control.
To use the remote control with your appliances, you must rst program Speedy Goal Plus as described below.
You can also visit our Internet site www.meliconi.com to have access to interactive instructions for easier and faster
remote control programming.
PROGRAMMING YOUR REMOTE CONTROL
Keep your Instructions Booklet for future reference.
USING THE KEYS AND FUNCTIONS
Control thevolume using +. Control thevolume using -. To select an external terminal. Mute key. To select the nextprogramme or to turn ON your TV.Press them togetherto turn ON your TVon programme 1.
To select the previous programme or to turn ON your TV.
ON/OFF to turn OFF your TV and,in some cases,to turn ON your TV.
SET-UP
Read these instructions carefully before programming your remote control!

PERSONALIZZALO

CON GLI STICKERS

DELLA TUA SQUADRA

DEL CUORE!

TELECOMANDO

UNIVERSALE

PER

T VTV

IF YOU DO NOT HAVE THE PROGRAMME SELECTION KEYS ON YOUR
ORIGINAL REMOTE CONTROL
If your remote control does not have the programme selection keys
(e.g. / , +/-, CH+/-..etc) once you have programmed
Speedy Goal Plus, you can still select the programmes from 0 to 9, as
follows:
Hold down the and keys simultaneously until the light
indicator starts to ash indicating that the remote control is
in programming mode.
• Release the keys and press 9 times within 12
seconds.
Three ashes
indicate that the operation has
been completed correctly.
• Make sure you can change programmes
from 0 to 9 using the and keys.
If not, repeat the search operation,
starting from point 2.
T
U

Mode d'emploi

Consultez gratuitement le manuel de la marque Meliconi Goal Plus ici. Ce manuel appartient à la catégorie Télécommandes et a été évalué par 1 personnes avec une moyenne de 6.8. Ce manuel est disponible dans les langues suivantes: Anglais. Vous avez une question sur le Goal Plus de la marque Meliconi ou avez-vous besoin d’aide? Posez votre question ici

Besoin d’aide?

Vous avez une question sur le Meliconi et la réponse n'est pas dans le manuel? Posez votre question ici. Fournissez une description claire et complète du problème, et de votre question. Plus votre problème et votre question sont clairement énoncés, plus les autres propriétaires de Samsung Galaxy A7 ont de chances de vous fournir une bonne réponse.

Nombre de questions : 0

Spécifications du Goal Plus de la marque Meliconi

Vous trouverez ci-dessous les spécifications du produit et les spécifications du manuel du Meliconi Goal Plus.

Généralités
Marque Meliconi
Modèle Goal Plus
Produit télécommande
EAN 8006023059935
Langue Anglais
Type de fichier PDF
représentation / réalisation
Nombre de périphériques supportés 1
Portée maximale - m
Design
Interface -
Couleur du produit Black,White
Utilisation adéquate de la télécommande TV
Type d'entrée Appuyez sur les boutons
Écran
Écran integré Non
Poids et dimensions
Poids - g
Batterie
Rechargeable -
Technologie batterie -
voir plus

Foire aux questions

Vous ne trouvez pas la réponse à votre question dans le manuel? Vous trouverez peut-être la réponse à votre question dans la FAQ sur le Meliconi Goal Plus au dessous de.

Votre question n'est pas dans la liste ? Posez votre question ici

Aucun résultat