Sony MDR-RF995RK mode d'emploi

Sony MDR-RF995RK
7.5 · 1
PDF mode d'emploi
 · 2 pages
Anglais
mode d'emploiSony MDR-RF995RK

Wireless Stereo

Headphone System

©2017 Sony Corporation Printed in Vietnam4-691-893-11(1)MDR-RF995RK
Operating Instructions
WARNING
To reduce the risk of fire or electric shock, do not
expose this apparatus to rain or moisture.
To reduce the risk of fire or electric shock, do not expose
this apparatus to dripping or splashing, and do not place
objects filled with liquids, such as vases, on the apparatus.
Do not expose the batteries (battery pack or batteries
installed) to excessive heat such as sunshine, fire or the
like for a long time.
To avoid electrical shock, do not open the cabinet. Refer
servicing to qualified personnel only.
Do not install the appliance in a confined space, such as a
bookcase or built-in cabinet.
The AC Adaptor is not disconnected from the mains as
long as it is connected to the AC outlet, even if the unit
itself has been turned off.
As the main plug of AC power adaptor is used to
disconnect the AC power adaptor from the mains, connect
it to an easily accessible AC outlet. Should you notice an
abnormality in it, disconnect it from the AC outlet
immediately.
Excessive sound pressure from earphones and
headphones can cause hearing loss.
The nameplate of transmitter is located on the bottom
exterior.
The nameplate of the headphones is located on the back
side of the slider.
Information
You are cautioned that any changes or modifications not
expressly approved in this manual could void your
authority to operate this equipment.
If you have any questions about this product, you may
call:
Sony Customer Information Services Center
1-800-222-7669 or http://www.sony.com/
Declaration of Conformity
Trade Name: SONY
Model No.: MDR-RF995R
(Headphones Unit)
Responsible Party: Sony Electronics Inc.
Address: 16535 Via Esprillo, San Diego, CA
92127 USA
Telephone No.: 858-942-2230
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1)
this device may not cause harmful interference, and (2)
this device must accept any interference received,
including interference that may cause undesired
operation.
Note
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions,
may cause harmful interference to radio communications.
However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception,
which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and
receiver.
Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
Consult the dealer or an experienced radio/ TV
technician for help.
For the customers in Canada
This device complies with Industry Canada’s licence-
exempt RSSs. Operation is subject to the following two
conditions:
(1)This device may not cause interference; and
(2)This device must accept any interference, including
interference that may cause undesired operation of the
device.
For the customers in the USA and CanadaRECYCLING NICKEL METAL HYDRIDE BATTERIES
Nickel Metal Hydride batteries are
recyclable. You can help preserve our
environment by returning your used
rechargeable batteries to the collection
and recycling location nearest you.
For more information regarding recycling of
rechargeable batteries, call toll free 1-800-822-8837, or
visit http://www.call2recycle.org
Caution:
Do not handle damaged or leaking Nickel Metal
Hydride batteries.

How to use

Connect the AC adaptor. Charge the headphones.
To AC
outlet
(Red) (Off)
Complete when indicator
turns off.
Check the CHARGE/
RED indicator lights
up red.
Connect the A/V component, following hookup or below. Using the headphone jack of the A/V component
Stereo mini plug
Headphone jack
(Stereo mini jack)
TV, Digital music player, etc.
L (white)
R (red)
Stereo mini plug
Audio out
(L/R) jacks
Stereo system, Blu-ray Disc player, DVD player, TV*, etc.
* In case of no headphone jack.
Adjust the volume.After use
Turn off the power of the headphones.
About sending RF signals
The transmitter starts sending RF signals
automatically when it detects an audio signal from
the connected component. Note that;
Noise may occur depending on the transmitter
position and room conditions. It is recommended
to place the transmitter in a location that
produces the clearest sound.
If the transmitter is placed on a metallic table,
you may hear noise, or the reception range may
decrease. Do not place on a metallic table.
If no signal or low signal is input for about 4 minutes
When no signal is input for about 4 minutes, the
transmitter turns off automatically*. The POWER
indicator of the transmitter blinks for 4 minites,
then turns off. The transmitter restarts after
receiving an audio signal again.
The transmitter may also turn off if low signal is
input for about 4 minutes. In this case, raise the
volume of the connected A/V component within
the range where the sound is not distorted, then
lower the volume of the headphones.
* If signal noise is output from the connected A/V
component, the transmitter may not turn off,
even when no audio signal is input.
Start playback of the A/V component.Wear the headphones.Before listening
To reduce the risk of hearing damage, first lower the volume.
Tactile dot
Up Down
Tactile dot
Using the audio out (L/R) jacks of the A/V component
Use a connection cable (not supplied) between the transmitter and the A/V component.
If the sound is distorted by connecting the transmitter to the A/V component’s audio out (L/R) jacks, reconnect the transmitter to the headphone jack.
If the transmitter detects no signal or no sound, check the connection of the connected A/V components, then check the audio setting of the connected A/V components.
Insert the supplied rechargeable battery BP-HP800-11 into the left housing of the headphones.
Observe the correct polarity when installing battery.
Rechargeable nickel-metal hydride
battery BP-HP800-11 (supplied)
Insert the
end first.
Checking the included
items
RF stereo transmitter
TMR-RF995R (1)
AC adaptor (1)
Wireless stereo
headphones MDR-RF995R
(1)
Stereo mini cable (stereo
mini plug), 1.5 m (1)
Rechargeable nickel-metal
hydride battery BP-
HP800-11 (1)
Features
Thank you for purchasing the Sony MDR-RF995RK
Wireless Stereo Headphone System. Before operating the
unit, please read this manual thoroughly and retain it for
future reference.
Some features are:
Wireless system that allows you to listen to a program
free the restriction of a cable
Up to 45 meters (150 feet) reception range*
High fidelity sound reproduction
New mode “VOICE” for clear hearing of personal voice
range
Noise reduction system to reproduce a clear sound with
minimum transmission noise
Comfortable fit
Smooth and Comfortable Earpads
Long playback time (maximum 20 hours)
Easy recharging function with secure charging
mechanism
Rechargeable Battery
Automatic tuning on headphones for optimum signal
reception
3 transmission channels available
Volume control function and sound effect function on
the headphones
* Transmission distance varies depending on conditions of
use
(Green)
4

2 3

7

5 6

1

Consultez gratuitement le manuel de la marque Sony MDR-RF995RK ici. Ce manuel appartient à la catégorie Écouteurs et a été évalué par 1 personnes avec une moyenne de 7.5. Ce manuel est disponible dans les langues suivantes: Anglais. Vous avez une question sur le MDR-RF995RK de la marque Sony ou avez-vous besoin d’aide? Posez votre question ici

Besoin d’aide?

Vous avez une question sur le Sony et la réponse n'est pas dans le manuel? Posez votre question ici. Fournissez une description claire et complète du problème, et de votre question. Plus votre problème et votre question sont clairement énoncés, plus les autres propriétaires de Sony ont de chances de vous fournir une bonne réponse.

Lili Caron • 13-6-2021Pas de commentaire

Mes ecouteurs ne se rechargent plus le bouton de la base de recharge est toujours ROUGE. Est-ce que l'OM peur avoir les instructions en français? Si oui, envoyez-moi le lien.Combien d'heures d'écoute une fois la recharge complète? J'ai pris une garantie supplémentaire et complèté sur internet toutes les informations de mes écouteurs acheté octobre 2017 au WALL MART

Répondez à cette question

Nombre de questions : 1

Généralités
Sony
MDR-RF995RK | MDRRF995RK
écouteur
0701980308390
Anglais
Mode d’emploi (PDF)
Casques/Ecouteurs
Sensibilité du casque100 dB
Impédance32 Ohm
Unité de lecture40 mm
Type d'aimantNéodyme
Type de piloteDynamique
Matériau du diaphragmePolyéthylène téréphthalate (PET)
Fréquence des écouteurs10 - 22000 Hz
Couplage auriculaireSupra-aural
Batterie
Lecture audio en continu20 h
Temps de rechargement de la batterie7 h
Poids et dimensions
Poids275 g
Connectivité
Technologie de connectivitéSans fil
représentation / réalisation
Couleur du produitNoir
Commande de volumeRotatif
Style de casque portableArceau
Type de produitÉcouteurs
voir plus

Vous ne trouvez pas la réponse à votre question dans le manuel? Vous trouverez peut-être la réponse à votre question dans la FAQ sur le Sony MDR-RF995RK au dessous de.

Votre question n'est pas dans la liste ? Posez votre question ici

Aucun résultat